Email steeringclutch@gmail.com
for orders or
questions.
CONTACT OUR OFFICE at 1-208-342-8911
General Gear and Machine
733 Desert Wind Rd., Boise, Idaho, 83716 US
KOMATSU D30 D30A D31 D31A
| We have had both dry clutch discs and oil type
clutch discs produced, both friction discs and steel separator plates, for the D30 D31
D30A AND D31A D31Psteering clutches. Quantities required are based upon your model, serial number, and the condition of your clutch. Check your clutches closely. You can often get by with only replacing the friction discs. Use your best judgment for evaluating your steel plates. You do not want to install plates that are rough and will accelerate the wear on your new fiber discs. Clean them with wire brushes, sandblasting, or whatever it takes to get them as smooth as possible and then make your decision. It is up to you of course, but unless you just like to pull wrenches, these steering clutches are not that much fun to have to remove and reinstall because you tried to save a hundred dollar bill.
ORDERING INFO: Our hours are Monday through Friday from 10 am Eastern Time to 6 pm Eastern Time (8 am Mtn Time to 4 pm Mtn Time). We are located 20 miles east of Boise, Idaho. 110-22-11332 Friction discs (DRY
CLUTCH) Our friction discs are the upgraded Bimetallic, bronze faced
for increased longevity and a higher coefficient of friction
32.00 ea 110-22-11320 Steel separator
plates (DRY CLUTCH) 21.00 ea
A complete clutch pack is normally 7
friction and 6 steels........A COMPLETE CLUTCH PACK WILL COST $350.00
D30/D31 OIL TYPE STEERING CLUTCH STEEL SEPARATOR
PLATES P/N
120-22-31221
|
||
email steeringclutch@gmail.com
|
In US only,
via Priority Mail, 2-3 day delivery, on orders $500 or higher.
